A protective grille prevents contact with the elements and the fan.

The drawer has an ON/OFF and temperature regulation dial. This dial is only visible when the drawer is open. When the drawer is closed, the indicator light on the front shows whether the appliance is switched on.

1. Place the crockery or plates with food in the drawer.

2. Set the desired temperature.

   • The ‘appliance on’ indicator will flash.

3. Close the drawer.

   • The ‘appliance on’ indicator will light up.

Use the temperature knob to set a temperature between 30 °C and 80 °C.

Icon Temperature Function Application 0 0 Off - 30 °C Defrosting For defrosting food. Allowing dough to rise. - 40 °C Defrosting 50 °C Warming cups and glasses. Warming coffee cups. 60 °C Warming crockery. Warming plates and dishes. Keeping food warm (eggs, bread). 70 °C Keeping food warm. Keeping food warm (meat, fish, vegetables). - 80 °C Keeping warm and Heating up Keeping food warm and reheating. 80 °C with fan Slow cooking After browning place the pan or dish in the drawer. Allow the dish to cook slowly for the recommended time.

The warming time for tableware depends on several factors:

• Material and thickness of the tableware.

• Fill level.

• Distribution of the load.

• Temperature control.

This means that it is not possible to give precise data in advance.

A few recommendations:

Even warming at a temperature of 60 °C will take:

• approximately 30 mins for crockery for a meal for six people.

• approximately 40 mins for crockery for a meal for twelve people.

You will learn from experience which timing suits your crockery best.

• This appliance should only be connected by a registered installer!

• The electrical connection must comply with national and local regulations.

• The wall plug socket and plug should always be accessible.

• If the power cord is damaged, it should be replaced by the manufacturer or an authorised service technician, in order to avoid hazard.

• If you want to make a fixed connection, make sure that a omnipolar switch with a contact separation of at least 3 mm is fitted in the supply cable.

• If a stationary appliance is not fitted with a supply cord and a plug, or with other means for disconnection from the supply mains having a contact separation in all poles that provide full disconnection under overvoltage category III conditions, the instructions shall state that means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.

• WARNING: Never open the appliance casing. The casing may only be opened by a service technician.

• Prior to connecting the drawer, ensure that all cables in your home’s electrical system are of sufficient diameter to supply the appliance properly.

• Complete all electrical connections before building in the appliance.

• Improper installation and maintenance work or repairs are dangerous. These may only be performed by authorized and trained technicians. If the appliance has a defect, please disconnect it and contact customer service.

• If the appliance is mounted behind a furniture front (e.g. a door), never close it while the appliance is in use. Heat and humidity accumulate behind a closed furniture front. This may damage drawer, cupboard and floor.

• Only use original replacement parts. These meet the required safety specifications.

• Please note that the appliance must not be mounted tilted or upended. The design of the appliance includes an oil-containing pump. Please refer to the installation instructions.

• The manufacturer cannot be held liable for any damage resulting from failure to follow the safety instructions and warnings.

Electrical connection

• This appliance is manufactured in Class I; this means the device must be grounded.

• Check whether the power of the electrical mains corresponds to the power on the identification plate on the appliance.

• Before connecting to the electrical mains, check whether the power socket is grounded.

• The device is equipped with a plug. When installing the appliance, remember that this plug must remain accessible.

This warming drawer is designed for use by individuals in their home. It is only intended for pre-warming tableware, keeping food warm and slow cooking. Any other use is prohibited and may be dangerous. The manufacturer disclaims liability in the event of improper use.

Under certain conditions, the outside of the warming drawer may reach 70 °C (depending on the selected temperature and length of use). Always use oven mitts or gloves to remove the warmed tableware from the drawer.

1. Slide the appliance in the kitchen cupboard aperture. Check whether the casing fits correctly.

2. Open the drawer and secure the appliance to the cupboard using the 4 screws supplied.

The front can be adjusted by a few millimetres for alignment with other appliances. Use the Allen key at the bottom of the appliance for this.

Sustainable materials have been used during the manufacture of this appliance. This appliance must be disposed of responsibly at the end of its service life. Ask your local authorities for more information about how to do this.

The appliance packaging is recyclable. The following may have been used:

• cardboard;

• polyethylene film (PE);

• CFC-free polystyrene (PS rigid foam).

Dispose of these materials in a responsible manner and in accordance with government regulations.